Model reference

Fisher & Paykel GWL08US

Washer

2 documents46 error codes2 service modes

Available documentation

Service Manual

Smart Drive Electronic Washing Machine Model GWL08US20 pg
Covers this model
SMART DRIVE ELECTRONIC WASHING MACHINE MODEL GWL08US Service Supplement20 pg
Covers this model

MyPros+ Max

Diagnose your Fisher & Paykel GWL08US.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Fisher & Paykel Washer

1 on my Fisher & Paykel GWL08US

M+

Motor Controller Module memory error.

From Service Manual 186031, p.43:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure drive motor winding resistance. Expected: 2 to 6 ohms between winding pairs.

3.Rotate the drum by hand. Inspect the belt and pulley for glaze or wear.

Part W10006384

Drive motor

Error codes (46)

CodeMeaning

1Motor Controller Module memory error.10Temperature sensor may be open circuit or ambient temperature is below -10°C.104Display to Motor Controller Module communications error (see fault code 106).105Display to Motor Controller Module communications error (see fault code 106).106Display to Motor Controller Module communications errors 107Motor Controller Module reset error 11Pressure sensor detected negative pressure while measuring water level…12Flood protection error 130Single Rotor Position Sensor error 131Repetitive Rotor Position Sensor error 132Single current trip 133Repetitive current trip 136Motor stall 160Basket engaged 161Hardware/EEPROM supply mismatch 162Brake deceleration time-out fault 163Valve reset pin connect fault 164Brake function time-out fault 192Motor PWM reset pin connect fault 2Error encountered when trying to read the pressure sensor.3Motor Controller Module memory error.36Water leak fault 37Pump blocked error 38Pressure sensor fault 39Pressure tube fault 40Basket dis-engage fault 41Temperature sensor fault 43Out of balance switch fault 44Water in basket during spin, possibly caused by slow pump out rate due to pump…45Display memory check fault

View all 46 error codes

47Basket dis-engage fault 48Both hot and cold water valves faulty 49Cold water valve faulty 50Hot water valve faulty 53Rotor Position Sensor step fail 54Motor/Motor Controller Module step fail 56Basket check no valid fault 57Brown out during Display EEPROM write 58Pressure transducer at maximum adjustment fault 59ID out of range fault 6Motor Controller Module received an incorrect signal from the pressure sensor.60Motor Controller memory check fault 61Brown out during Motor Controller EEPROM write 7Display Module has found a memory fault.81-95Display to Motor Controller Module communications errors (see fault code 106).9Display size switch setting does not match that stored in memory.

Service modes (2)

Diagnostic Mode["Turn the power on at the power point and off at the console.","Press and hold the WASH…
Machine Size Setting Mode["Turn the power on at the power point and off at the console.","Press and hold the WASH TEMP UP…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Fisher & Paykel washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass