Model reference

Maytag W11316891

Name: Maytag W11316891
Brand: Maytag

Washer

1 document25 error codes4 service modes

Available documentation

Tech Sheet

Basic Operation of Commercial Stacked Washer/Dryer44 pg
Covers this model

MyPros+ Max

Diagnose your Maytag W11316891.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Maytag Washer

d13 on my Maytag W11316891

M+

Coin 2 error; blocked coin 2 or coin

From Tech Sheet W10628442, p.14:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure door lock assembly resistance across PTC terminals. Expected: ~200 ohms cold.

3.Inspect strike and latch alignment. A misaligned strike prevents the switch stack from closing.

Part W10810403

Door lock assembly

Error codes (25)

CodeMeaning

d13Coin 2 error; blocked coin 2 or coin drop UI control circuit failure (coin…d16Generation 2 debit card reader error; no communication from installed debit…d5Coin 1 error; blocked coin 1 or coin drop UI control circuit failure (coin…d9Low voltage detection error; voltage detected below 90 VAC for 8 seconds.F01Washer CCU error; communication error within the Central Control Unit, pump…F03Washer accelerometer failure; the X, Y, and Z limits are outside of the normal…F04Washer accelerometer failure; the X, Y, and Z limits are outside of the normal…F11Washer MCU error; Motor Control Unit has a failure, possibly repeating under or…F20No water detected entering washer; first level of pressure switch not tripped…F21Long drain; drain time exceeds 8 minutes without reaching reset level in…F22Dryer exhaust thermistor open; temperature drops below 18°F (>50 kΩ) for 1…F23Dryer exhaust thermistor shorted; temperature above 250°F (<500 Ω) for 1 minute…F24Temperature sensor error; water temperature sensor value is out of range (23°F…F25Tachometer error; MCU unable to properly detect motor speed, washer shuts down.F26Door switch error; door switch circuit is open for 5 seconds while door is…F27Overflow condition; overflow contact on pressure switch is closed for more than…F28Communication failure between CCU and MCU.F29Door unlock error; door is unable to unlock after six tries.F31Overheating of motor; heat sink exceeds 212°F (100°C).F33Pump disconnected; electrical connection between the pump and the CCU is lost.F34Load detected in washer during washer cleanout cycle.F70Communication failure from CCU to UIC; UIC is not receiving communications from…F71Communication failure from UIC to CCU; CCU is not receiving communications from…F73UIC Microprocessor error; UIC microprocessor is not able to read or verify…F74UIC EEPROM error; UIC EEPROM memory CRC failure.

Service modes (4)

Help Mode (dAS Mode)["Open the service door or insert a manual diagnostic card.","The message dAS will appear in the…
Help Mode (PD Models)["Open the service door.","Press the EXTRA RINSE washer key pad until display reads 2.XX.","Press…
Service Diagnostic Test Mode["Enter Set-Up Mode (insert service switch key and turn counter-clockwise).","Make sure the…
Set-Up Mode["PD/PR Models

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass