Model reference
Samsung WA44A3205AW/A4
Washer
2 documents32 error codes7 service modes
Available documentation
Service Manual
- Service Washing Machine (Top-loading)40 pg
- LAVE-LINGE (CHARGEMENT PAR LE HAUT) Manuel d'ENTRETIEN RONDELLE DE CHARGEMENT SUPÉRIEUR26 pg
MyPros+ Max
Diagnose your Samsung WA44A3205AW/A4.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (32)
CodeMeaning
1CWater level sensor is not working properly.3CMotor operation error (wash motor error / TMR sensor error).4CNo water supply to the washer.4C2Cold water supply hose is connected to the hot water tap instead of the cold…5CWater does not drain.8CMain equipped board error due to disconnection or sub board defect.8C1Main equipped board error due to disconnection or sub board defect.8C2Main equipped board error due to disconnection or sub board defect.9C1Overvoltage detected9C2Low voltage detected.ACCommunication errorAC6Communication problem with the inverter.BC2Switch error (main relay error)CACommunication errordCDoor is open during operation.DC1Door lock switch is not inserted or is damaged.DC2Door lock switch wire is disconnected or the switch is defective.HCHigh temperature heating check.LCWater leak detectedLC1Water leak errorOCWater overflow detected.PCClutch position cannot be detected.PC1After clutch position detection, the clutch input signal is erroneous.TCTemperature sensor error (wash temperature sensor fault).TC1Wash temperature heater sensor fault.TC2Dry temperature heater sensor fault.TC3Dry condensation sensor connection fault.TC4IPM temperature is abnormally high.UbSpin cycle does not work due to unbalanced load.UCPower supply condition faultService modes (7)
- Automatic check modeEnter Smart Install mode, then press Start/Pause while displaying 'AS'
- Diagnosis Information Display ModeWhile 'AS' identity is displayed, press the first button on the right at the bottom
- Diagnostic Code CheckEnter Smart Install mode, then press Temp + Start while displaying 'AS'.
- Manual check modeEnter Smart Install mode, then press Water Level while displaying 'AS'
- S/W version CheckEnter Smart Install mode, then press the first button on the left at the bottom while displaying…
- Smart InstallFrom standby, choose SELFCLEAN course, then press Start/Pause for 7 seconds.
- Smart Install Result EnquiryWhile 'AS' identity is displayed, press Delay End + Start/Pause button.
Full entry steps, exit procedures, and test sequences are available in Max.
Related Samsung washer models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass