mypros+
Model reference

Samsung WA45T3200AW/A4

Washer

3 documents32 error codes6 service modes

Available documentation

Service Manual

  • LAVE-LINGE (CHARGEMENT PAR LE HAUT) Manuel d'entretien RONDELLE DE CHARGEMENT SUPÉRIEURE26 pg
    Covers this model
  • Washing Machine (Top-loading) Service Manual25 pg
    Covers this model
  • Service Washing Machine (Top-loading)38 pg
    Covers this model
MyPros+ Max

Diagnose your Samsung WA45T3200AW/A4.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (32)

CodeMeaning
1CThe water level sensor is not working properly.3CMotor operation error (washing motor fault or TMR sensor error).4CWater supply error4C2Cold water supply hose is not firmly connected to the cold water valve, or…5CDrain error8CMain equipped board error8C1Main equipped board error8C2Main equipped board error9C1Over voltage error9C2Low voltage detected.ACCommunication errorAC6Inverter communication problem.BC2Switch error (main relay error)CACommunication errordCOperating the washer with the door open.DC1Door lock switch is not inserted or the wire is disconnected.DC2Door lock switch unit is damaged or defective, possibly due to main PCB fault.HCHigh temperature heating check.LCWater leak errorLC1Water leak errorOCOverflow errorPCPosition of the clutch cannot be detected.PC1After position of the clutch is detected, the signal of the clutch hall goes…TCTemperature sensor errorTC1Wash temperature sensor fault.TC2Dry heater temperature sensor fault.TC3Dry condensation sensor defective connections or main PCB failure.TC4IPM temperature is abnormally high.UbUnbalance errorUCPower supply error (also 9C1/9C2)
View all 32 error codes
UEUnbalance errorUrUnbalanced condition; additional rinsing is added during sensing unbalance.

Service modes (6)

  • Automatic Check Mode["Enter Smart Install mode.","Press Start/Pause while displaying 'AS'."]
  • Diagnostic Code Check["Enter Smart Install mode.","Press the first button on the right at the bottom while displaying…
  • Manual Check Mode["Enter Smart Install mode.","Press Delay End while displaying 'AS'.","Press Delay End again to…
  • S/W Version Check["Enter Smart Install mode.","Press the first button on the bottom while displaying 'AS'."]
  • Smart Install["From standby, set the scheduled time to 17:00.","Press Start/Pause for 7 seconds."]
  • Smart Install TestReferenced as 'Smart Install' test mode throughout troubleshooting sections

Full entry steps, exit procedures, and test sequences are available in Max.

Related Samsung washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass