mypros+
Model reference

LG WF410ANRXAA

Washer

9 documents41 error codes26 service modes

Available documentation

Service Manual

  • Washing Machine Drum Type Service Manual45 pg
    Covers this model
  • Washing Machine Drum Type Service Manual3 pg
    Covers this model
  • Troubleshooting12 pg
    Covers this model
  • LG Samsung WF410ANRXAA sm 03 Disassembly n Reassembly11 pg
    Covers this model
  • LG Samsung WF410ANRXAA sm 01 Precaution4 pg
    Covers this model
  • Error Code Washer16 pg
    Covers this model

Tech Sheet

  • LG Samsung WF410ANRXAA sm 02 Product Specification5 pg
    Covers this model

Wiring Diagram

  • LG Samsung WF410ANRXAA sm 07 Schematic Diagram3 pg
    Covers this model
  • PCB Diagram6 pg
    Covers this model
MyPros+ Max

Diagnose your LG WF410ANRXAA.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (41)

CodeMeaning
1EWater level frequency is continuously over 30kHz or below 15kHz for 10 seconds…2EVoltage for motor control bus is over or under specified limit.3EMotor overloaded due to too much laundry or motor coil open/cut.3E1Defective Hall Sensor or hall sensor terminal not connected.3E2Motor wire connection fault on Main PBA or Main PBA fault.4EWater level does not increase more than 100Hz from previous water level every 3…5EUnit does not reach target water level after 15 minutes of draining, indicating…7ESilver Care Kit (PCB) Failure.8EThe signal of tub location is out of normal range in Mems sensor during…8E1The signal of tub location is out of normal range in Mems sensor during…8E2Rear Mems faultAECommunication error between Main PBA and Sub PBA for over 24 seconds.AE6Communication error between Main PBA and Sub PBA for over 24 seconds (front…bE1A button on the control panel is continually pressed for over 30 seconds.bE2A button on the control panel is continually pressed for over 30 seconds.C/UEWasher detects unbalance 3 times during operation.dEDoor-Lock switch does not detect that the door is closed (Reed S/W for top…dE1Door lock/unlock has failed continuously seven times.dsDoor is detected as open while the unit is trying to lock the door (diagnostic…fLDoor lock/unlock has failed continuously seven times.HEHeater fault detected.HE1Heater fault or temperature sensor fault at center of dryer.HrHeater Relay FailureLEWater level frequency above 30kHz detected for 5 seconds during wash/rinse…LE1Water level frequency above 30kHz detected for 5 seconds during wash/rinse…LODoor lock/unlock has failed continuously seven times.ndThe water level fails to drop below the Reset Water Level within 15 minutes…nFWater level does not increase more than 100Hz from previous water level every 3…nF1The hot/cold water hose connection is not correct (diagnostic code 5).OEWater level frequency below 21kHz detected for 10 seconds, possibly caused by…
View all 41 error codes
PEClutch motor position detection signal not received within 15 seconds after…PE1Hall sensor location detection fails 15 times after running the clutch motor…SF1System Error.SF2System Error.SF3System Error.SrSystem Relay (Main Relay) FailuresudToo much foaming detected during operation.sudsSuds is detected during the washing session; not a true errortEWasher detects water temperature is lower than -3 degrees C during heater on…tE1Washer detects water temperature is lower than -3 degrees C during heater on…tUHSensor bar is short in tSt or SPn test mode.

Service modes (26)

  • Board Input Test Mode["Activate Service Mode first.","Press the My Cycle (or Pure Cycle or Steam) key during Service…
  • Continuous Run Mode["From Power On State (Normal User Mode), press Delay Start Key and Extra Rinse Key together for 3…
  • Cycle Count Check Mode["Activate Service Mode first.","Press the Signal Key during Service Mode."]
  • Demo Mode["From Normal User Mode (while a cycle is not running), press Delay Start + My Cycle (or Pure Cycle…
  • Diagnostic Code Check Mode["Activate Service Mode first.","Press the Extra Rinse key during Service Mode
  • Diagnostic Mode - A-Type (WA45H7*** / WA48H7*** / WA56H9***)From Service Mode, press the Spin key to start Diagnostic Code Check Mode (Code 'd' flashing)
  • Diagnostic Mode - B-Type (WA50F9*****)From Service Mode, press the Spin key to start Diagnostic Code Check Mode (Code 'd' flashing)
  • Diagnostic Mode - C-Type (WA400*** / WA422***)From Service Mode, press the Spin key to start Diagnostic Code Check Mode (Code 'd' flashing)
  • Diagnostic Mode - D-Type (WA456***)From Service Mode, press the Spin key to start Diagnostic Code Check Mode (Code 'd' flashing)
  • Diagnostic Mode - E-Type (WF42H5*** / WF45H6*** / WF56H9***)From Service Mode, press the Spin key to start Diagnostic Code Check Mode (Code 'd' flashing)
  • Diagnostic Mode - F-Type (WF393*** / WF405*** / WF433*** / WF455***)From Service Mode, press the Spin key to start Diagnostic Code Check Mode (Code 'd' flashing)
  • Diagnostic Mode - G-Type (WF457***)From Service Mode, press the 3 key on the bottom to start Diagnostic Code Check Mode (Code 'd'…
  • EEPROM Clear Mode["The unit needs to be on.","Press Delay Start Key, Signal Key, and Power Key at the same time."]
  • Fast Time Down Test Mode["Activate Service Mode first.","Press the Temp key during Service Mode."]
  • Quick Spin Test Mode["Enter Service Mode first.","During Service Mode, press the Delay Start and My Cycle (or Pure…
  • Quick Test Mode["Plug in the unit (power off state).","Press Soil Key, Signal Key, and Power Key at the same…
  • S/W Version Check Mode["Activate Service Mode first.","Press the Soil Level Key during Service Mode."]
  • Service Mode["The washer must be on.","Press the Signal and Extra Rinse Keys for 3 seconds or until the unit…
  • Service Mode - A-Type (WA45H7*** / WA48H7*** / WA56H9***)During power on status or normal operation, press Delay End + Pre Soak at the same time for 3…
  • Service Mode - B-Type (WA50F9*****)During power on status or normal operation, press Delay Start + Pre Soak at the same time for 3…
  • Service Mode - C-Type (WA400*** / WA422***)During power on status or normal operation, press Delay Start + Extra Rinse at the same time for 3…
  • Service Mode - D-Type (WA456***)During power on status or normal operation, press Delay Start + Aqua Jet at the same time for 3…
  • Service Mode - E-Type (WF42H5*** / WF45H6*** / WF56H9***)During power on status or normal operation, press Soil Level + Delay End at the same time for 3…
  • Service Mode - F-Type (WF393*** / WF405*** / WF433*** / WF455***)During power on status or normal operation, press Signal + Extra Rinse at the same time for 3…
  • Service Mode - G-Type (WF457***)During power on status or normal operation, tap Segment '4' three times, tap Segment '1' two times…
  • Water Level Check ModeWith no power, press Spin + Soil Level + Power at the same time, then turn knob dial 3 turns in CCW…

Full entry steps, exit procedures, and test sequences are available in Max.

Related LG washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass