Model reference

Samsung HA138UW

Name: Samsung HA138UW
Brand: Samsung

Washer

5 documents35 error codes

Available documentation

Service Manual

LG Samsung WR HA138UW 4 map13 pg
Covers this model
LG Samsung WR HA138UW 1 map4 pg
Covers this model

Wiring Diagram

LG Samsung WR HA138UW 8 map3 pg
Covers this model

Other

LG Samsung WR HA138UW cover map1 pg
Covers this model
LG Samsung WR HA138UW 7 map1 pg
Covers this model

MyPros+ Max

Diagnose your Samsung HA138UW.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Samsung Washer

1E on my Samsung HA138UW

M+

Water level sensor error caused by

From Service Manual 618863, p.35:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure door lock assembly resistance across PTC terminals. Expected: ~200 ohms cold.

3.Inspect strike and latch alignment. A misaligned strike prevents the switch stack from closing.

Part DC34-00024B

Door lock assembly

Error codes (35)

CodeMeaning

1EWater level sensor error caused by damaged sensor hose, debris blockage, kinked…3EMotor operation failure or Hall sensor error 3E1Motor overload due to excessive laundry load or motor Hall sensor terminal not…3E2Weak motor drive signal from PBA, relay instability, or motor Hall sensor…3E3Motor Hall sensor erroneous signal or main PBA IPM terminal not inserted.3E4DD motor cover eccentricity, PCB housing terminal insertion failure, PBA…4EWater supply error caused by foreign material in water inlet valve, valve…4E1Hot and cold water supply hoses connected in reverse.4E2Water temperature exceeds 50°C during wool/lingerie cycle or exceeds 70°C…5EDrain error caused by drain pump impeller damage, wrong voltage part (220V vs…8EMotor Hall sensor not detected causing unstable motor startup, or PBA IPM…9E1Power supply abnormality 9E2Power supply abnormality AECommunication error between sub PBA and main PBA bE1Power switch button stuck/pressed for more than 12 seconds, or control panel…bE2Any button other than power switch is stuck/pressed for more than 30 seconds…bE3Main PBA relay short circuit or main relay terminal mis-insertion (bent…CECooling error dEDoor error (before operation)dE1Door lock switch terminal not inserted or damaged; wire leakage causing…dE2Door lock coil overheated from repeated rapid power switch ON/OFF cycles…FEDryer duct fan motor error HEHeater error HE1Wash heater temperature sensor failure (poor contact or sensor defect), or…HE2Dryer heater center red overheat temperature sensor activated (above 145°C)HE3Steam function malfunction LEWater leak error LE1Water leak detected OEOverflow error PFPower failure error

View all 35 error codes

SudExcessive foam/suds detected tE1Wash tub heater temperature sensor failure (poor contact or sensor defect)…tE2Duct assembly fan housing temperature sensor failure (internal short, open…tE3Duct condensing temperature sensor open or short circuit UEUnbalance error

Related Samsung washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass