Model reference

Samsung WA50F9A7DSP/A2-00

Name: Samsung WA50F9A7DSP/A2-00
Brand: Samsung

Washer

1 document1 error code15 service modes

Available documentation

Tech Sheet

Fast Track Troubleshooting9 pg
Covers this model

MyPros+ Max

Diagnose your Samsung WA50F9A7DSP/A2-00.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Samsung Washer

EEEE on my Samsung WA50F9A7DSP/A2-00

M+

The PCB assembly is defective.

From Service Manual 802578, p.30:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part DA92-00384N

Main PCB assembly

Error codes (1)

CodeMeaning

EEEEThe PCB assembly is defective.

Service modes (15)

Circulation/Drain Pump Test (within Quick Test Mode)In Quick Test Mode, press Spin to test Circulation/Drain Pump.
Cycle Count (within Service Mode)While in Service Mode, press Pre Soak to see how many times the unit was used.
Door Lock Switch Status (Peripheral Input Test within Quick Test Mode)In Quick Test Mode, select Eco Plus, then turn the Jog-Dial so that the Quick Wash LED is turned on
Door Lock/Unlock Circuit Test (within Quick Test Mode)In Quick Test Mode, press My Cycle to test Door Lock/Unlock circuit.
Door Status Display (Peripheral Input Test within Quick Test Mode)In Quick Test Mode, select Eco Plus, then turn the Jog-Dial so that the Delicates/Hand Wash LED is…
Fault Code Test (within Service Mode)While in Service Mode, press Spin to view stored fault codes, then turn Jog Dial to view error codes
Motor Test (within Quick Test Mode)When either Test or Spin is displayed on the LCD, press Start/Pause to conduct the motor test
Quick Spin Test (within Service Mode)While in Service Mode, press and hold Delay Start & Softener Option
Quick Test ModeWith the power OFF, press Spin, Soil, & Power simultaneously.
Service ModeWith the power ON, press Delay Start & Pre Soak simultaneously.
Software Version (within Service Mode)While in Service Mode, press Soil Level to see the SW version information.
Water Level Frequency Display (Peripheral Input Test within Quick Test Mode)In Quick Test Mode, select Eco Plus, then turn the Jog-Dial so that the Pure Cycle LED is turned on
Water Temperature Display (Peripheral Input Test within Quick Test Mode)In Quick Test Mode, select Eco Plus, then turn the Jog-Dial so that the Perm Press LED is turned…
Water Valves Circuit Test (within Quick Test Mode)In Quick Test Mode, turn the Jog-Dial CCW so that the version disappears, then press Temp to cycle…
Water/Steam Heater Test (within Quick Test Mode)In Quick Test Mode, press Soil to test the Water/Steam Heater.

Full entry steps, exit procedures, and test sequences are available in Max.

Related Samsung washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass