Bosch Washer Error Code F:60

F:60 means the flow sensor is detecting water intake values that are either too low or too high, outside of the normal operating range. This can be caused by a broken flow sensor, turbulent water passing through the sensor or hose, or a clogged filter in the solenoid valve. When this code appears, the washer automatically switches from volume-based water measurement to a time-based fill method as a fallback. Resolving the underlying cause is necessary to restore accurate water intake control.

Running the washer with F:60 active is generally not recommended for the long term. While the machine does switch to a time-based fill method as a fallback, this means water levels may not be accurately controlled, which can affect wash quality and potentially lead to overfill or underfill conditions. It is best to diagnose and resolve the fault before continuing regular use.

Repair costs vary depending on the cause. If the fix is simply cleaning the solenoid valve inlet filters, the cost is minimal, typically just the time for the repair. If the flow sensor needs to be replaced, parts alone generally range from around 30 to 80 dollars, with professional labor adding another 100 to 200 dollars depending on your location and the service provider. Wiring harness repairs fall somewhere in between depending on the extent of the damage.

Some causes of F:60 are DIY-friendly, particularly cleaning the inlet filter screens in the solenoid valve and inspecting the wire harness for loose or corroded connections. Checking for kinked or improperly routed inlet hoses is also straightforward. If these steps do not clear the code, the flow sensor itself may need to be tested and replaced, which requires a moderate level of comfort with appliance disassembly.

A reset may temporarily clear the F:60 code, but if the underlying fault persists, the error will return during the next wash cycle when the control board again detects out-of-range flow sensor values. A reset alone does not fix a clogged inlet filter, a faulty sensor, or a wiring problem. The root cause must be corrected for the code to stay cleared.