mypros+
Model reference

GE GHWSHMC

Washer

1 document40 error codes2 service modes

Available documentation

Service Manual

  • GE CleanSpeak Top Load Washers Technical Service Guide93 pg
    Covers this model
MyPros+ Max

Diagnose your GE GHWSHMC.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (40)

CodeMeaning
1UI EEPROM board software not operating correctly.10Slow fill11Heater not reaching target temperature.12IMC (Inverter Machine Control) communication time-out, no operation.16Mode shifter not engaged to spin.17Mode shifter not engaged to agitate.18Mode shifter taking too long to engage.19Flood protection5Bulk Dispense detergent and fabric softener not dispensing properly.6Bulk Dispense detergent and fabric softener not dispensing properly.65Lid lock will not lock or unlock or is locked while lid is opened.66Lid lock will not lock or unlock or is locked while lid is opened.68Pressure sensor error6AThermistor error6BThermistor error7Stuck button72Inverter spin redundancy75Lid lock will not lock or unlock or is locked while lid is opened.76Detergent bulk dispenser sensor not reading correctly.77Softener bulk dispenser sensor not reading correctly.8Pressure sensor not filling as designed.9Lid lock will not lock or unlock or is locked while lid is opened.ANo fillBDrain pumpC9IMC (Inverter Machine Control) fault.CAIMC (Inverter Machine Control) fault.CBDC bus brownout (voltage too low) or DC bus high (voltage too high).CCMotor temperature high.CDIMC (Inverter Machine Control) fault.CEIMC (Inverter Machine Control) fault.
View all 40 error codes
CFIMC (Inverter Machine Control) fault.DIMC (Inverter Machine Control) communication time-out, no operation.D2Locked rotor.D3Hall sensor faultD5IMC (Inverter Machine Control) fault.DDIMC (Inverter Machine Control) fault.DEIMC (Inverter Machine Control) fault.DFIMC (Inverter Machine Control) fault.ELid lock will not lock or unlock or is locked while lid is opened.FHeater water level

Service modes (2)

  • Bulk Tank Special Features Mode1
  • Field Service ModePress and hold the Start pad while rotating the Cycle Selection knob 360 degrees (1 click), then…

Full entry steps, exit procedures, and test sequences are available in Max.

Related GE washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass