Model reference

GE GNE26GSDCSS

Refrigerator

3 documents110 error codes1 service mode

Available documentation

Tech Sheet

Technical Data - GNE26G*D*** Bottom Freezer2 pg
Covers this model

Service Manual

GE Refrigerator Wiring and Service Diagnostic4 pg
Covers this model

Tech Tip

Articulating Mullion Not Engaging1 pg
Covers this model

MyPros+ Max

Diagnose your GE GNE26GSDCSS.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·GE Refrigerator

0001 on my GE GNE26GSDCSS

M+

FF Thermistor reading out of range

From Service Manual 127439, p.51:

1.Access service mode to confirm the active fault code and read stored error history.

2.Disconnect the sensor and measure resistance. Expected: 10 kΩ to 12 kΩ at 77°F (25°C).

3.Check the sensor harness for opens. A reading outside 5 kΩ to 50 kΩ indicates a failed sensor.

Part WR55X10025

Temperature sensor

Error codes (110)

CodeMeaning

0001FF Thermistor reading out of range 0002N/A 0003FZ Thermistor reading out of range 0004FZ Evaporator Thermistor reading out of range 0005Electronic Deli Pan Thermistor reading out of range 0006FF Evaporator Thermistor reading out of range 0007N/A 0008Ambient Temperature Thermistor reading out of range 0009Ambient Humidity Sensor reading out of range 0010FZ Icemaker Thermistor reading out of range (if applicable)0011N/A 0012N/A 0100FZ Fan Feedback Missing when Fan is running 0101FZ Fan Feedback Present when Fan is off 0102FZ Fan cannot reach target speed 0103Condenser Fan Feedback Missing when Fan is running 0104Condenser Fan Feedback Present when Fan is off 0105Condenser Fan cannot reach target speed 0106FF Fan Feedback Missing when Fan is running 0107FF Fan Feedback Present when Fan is off 0108FF Fan cannot reach target speed 0109Ice Box Fan Feedback Missing when Fan is running 0110Ice Box Fan Feedback Present when Fan is off 0111Ice Box Fan cannot reach target speed 0112Deli Pan Fan Feedback Missing when Fan is running 0113Deli Pan Fan Feedback Present when Fan is off 0114Deli Pan Fan cannot reach target speed 0115Odor Remover Fan Feedback Missing when Fan is running 0116Odor Remover Fan Feedback Present when Fan is off 0117Odor Remover Fan cannot reach target speed

View all 110 error codes

0200FZ Defrost Heater timed out 0201FF Defrost Heater timed out 02025 consecutive FZ extended defrosts 02035 consecutive FF extended defrosts 0300N/A 0301Temperature satisfied > 3 hours (no compressor operation)0302N/A 0303FF Temp Exceeds > 50 F 0304FZ Temp Exceeds > 25 F 0305N/A 0306N/A 0307N/A 0400N/A 0401N/A 0402N/A 0403Mainboard Software Fault 0404Mainboard Hardware Fault 0500Main board Relay driver is shorted 0501Can't reach Target Hot Water Temp 0502Flow meter 0503Flow meter signal received with no water dispensing 0504Paddle switch pressed > 7 minutes 0505Hot water tank filling error 0506N/A 0507N/A 0508Check Paddle switch and wiring 0509Check Paddle switch and wiring 0510Check Hot water T & P switch and wiring 0511Check Hot water T&P switch and wiring 0512FF IM Thermistor reading out of range 0513Ice Box Thermistor reading out of range 0514Hot Water Thermistor reading out of range 0515Hot Water Thermistor reading out of range 0516Door board Hardware fault 0517Hot Water tank Fault 0518Door board Hardware fault 0519Low Flow Rate, Hot Water Disabled 0520N/A 0521HW Max Fill Time Out Hot water disabled 0522HW Max Dispense Time Out Hot water disabled 0600FF IM Harvest Extended >10 mins 0601FF IM Harvest Extended 3 out of 10 harvests 0602FF IM Harvest Not Completed after 30 mins 0603FF IM No water supply detected 0604FF IM continues to sense bucket full after ice dispense 0605FF IM Moldheater not heating 0606N/A 0650FZ IM Harvest Extended >10 mins 0651FZ IM Harvest Extended 3 out of 10 harvests 0652FZ IM Harvest Not Completed after 30 mins 0653FZ IM No water supply detected 0654FZ IM Moldheater not heating 0655N/A (placeholder)0700Stuck keys on Dispenser Boards 0701Stuck Keys on Internal Temp Board 0702Stuck Keys on Deli Pan 0703Key Press on Temp Board while Door Closed 0704Key Pressed on Deli Pan Board while Door Closed 0705Dispenser Board Auto Fill Error 0706Dispenser Board Auto Fill Error 0707Dispenser Board Error 0708Dispenser Board Error 0709Check Paddle switch and wiring 0710Check Paddle switch and wiring 0711Check Hot water T & P switch and wiring 0712Check Hot water T&P switch and wiring 0713FF Door open for 15 minutes continuously 0714FF Door open for 60 mins total in the last 24 hours 071550 FF Left Door Openings in the last 24 hours 071650 FF Right Door Openings in the last 24 hours 0717FZ Door open for 15 minutes continuously 0718FZ Door open for 60 mins total in the last 24 hours 071950 FZ Door Openings in the last 24 hours 0720N/A 0721Upper Auto Fill Sensor Error 0722Display board error 0800RFID board hardware failure / check filter and filter orientation 0801RFID board failed to respond to MB 0802RFID board not detecting filter tag / check filter and filter orientation 0803RFID filter authentication failed / check filter and filter orientation

Service modes (1)

Service DiagnosticsPress the 'Water', 'Crushed', and 'Cubed' buttons simultaneously for 3 seconds

Full entry steps, exit procedures, and test sequences are available in Max.

Related GE refrigerator models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass