mypros+
Model reference

Fisher & Paykel MW612-NZ

Washer

1 document58 error codes9 service modes

Available documentation

Service Manual

  • Smartdrive Phase 7 Electronic Washing Machines62 pg
    Covers this model
MyPros+ Max

Diagnose your Fisher & Paykel MW612-NZ.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (58)

CodeMeaning
1Motor Control Module EEPROM write error.10Temperature sensor (thermistor) may be open circuit or ambient temperature…104See fault code 106105Communications error timeout106Display Module to Motor Control Module communications error.107Motor Control Module reset error108Communications CRC error109AC Pump Triac over temperature110Motor bridge thermistor open circuit111Motor bridge thermistor short circuit.112Motor current sense too high113AC Pump thermistor short circuit12Flood protection error130Single Rotor Position Sensor error136Motor stall160Bowl engaged220EEPROM Model Map not programmed (similar to fault code 60).230EEPROM value out of range232COMMS timeout 5 seconds233EEPROM read error234Lid Lock open circuit235Lid Lock short circuit236Incompatible EEPROM version237Temperature sensor error238Lid Lock fail in-line test (1)239Lid Lock fail in-line test (2)240Hall out of order / RPS fault241Function time out243Stepper test failure245SmartPump stall
View all 58 error codes
247SmartPump flapper fault248SmartPump top up fault249SmartPump timeout fault250SmartPump loss of sync252Bridge test failure26Detergent valve (Purple Clip) fault27Fabric softener valve (Yellow Clip) fault3Motor Control Module memory error.36Water leak fault37Pump blocked error38Pressure sensor fault39Pressure tube fault40Bowl dis-engage fault41Temperature sensor fault45Display memory check fault46Display Memory EEPROM check fault49Cold valve or both cold and hot valves faulty50Hot valve faulty51Diverter valve fault52Diverter top-up fault56Bowl check no valid fault57Brown out during Display EEPROM write fault60Motor Control memory check fault68Pressure transducer error69Pressure transducer error70Pressure transducer error72Pressure transducer error9Display size switch setting does not match that stored in memory.

Service modes (9)

  • Controlled Cold Adjustment (GW Only)1
  • Data Download1
  • Demonstration ModePress and hold ADVANCE, then press POWER.
  • Diagnostic Mode1
  • Recycle Feature (Service Aid)1
  • Restart Feature (Service Aid)1
  • Size Setting Mode1
  • Warm Wash Temperature Adjustment (MW Only)1
  • Wash Temperature Adjustment (GW Only)1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Fisher & Paykel washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass