Electrolux Range Error Code LEDs 1,2

LEDs 1 and 2 illuminated together on an Electrolux range indicate a runaway temperature fault, meaning the oven's control system has detected that the oven temperature exceeded safe operating limits. The control board monitors the oven temperature probe continuously and triggers this fault when it receives readings that suggest the oven is dangerously hot. This is a safety lockout condition that requires diagnosis before the oven can be used again.

Cycling power to the range may temporarily clear the fault display, but if the underlying problem with the temperature probe or control board is not corrected, the error will return once the oven is used again. A reset does not fix the root cause and should not be relied upon as a solution. Always diagnose and repair the fault before returning the appliance to service.

Repair costs vary depending on which component has failed. An oven temperature probe is generally the less expensive fix, with parts typically ranging from $20 to $60 plus labor if a technician is doing the work. Replacing the electronic control board is more costly, with parts often ranging from $150 to $350 or more depending on the specific model, plus labor. Getting a diagnostic visit from a qualified appliance technician will help confirm which part is at fault before purchasing components.

No, the oven should not be used while this fault is active. A runaway temperature condition means the oven's safety limits have been exceeded, which poses a potential fire and burn hazard. Stop using the oven, disconnect power if the oven is still running, and have the temperature probe and control board inspected before attempting to cook again.

Start by testing the resistance of the oven temperature probe with a multimeter. At room temperature, the probe should read between 1050 and 1100 ohms. If the reading falls outside that range, replace the probe. If the probe tests within specification, the electronic control board is the next likely cause and should be replaced. Also inspect the wiring harness between the probe and board for any damage.