mypros+
Model reference

Fisher & Paykel MW060

Washer

2 documents87 error codes7 service modes

Available documentation

Service Manual

  • SMART DRIVE ELECTRONIC WASHING MACHINE PHASE 1 to 5 – 230v92 pg
    Covers this model

Bulletin

  • Technical Bulletin - SMARTDRIVES Alternative Spare Parts for Motor Controller Module 425243P3 pg
    Covers this model
MyPros+ Max

Diagnose your Fisher & Paykel MW060.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (87)

CodeMeaning
1Phase 110Thermistor error104Phase 2-5105Phase 2-5106Phase 2-3107Phase 2-5: Motor Controller fault11Pressure sensor fault12Flood protection error127Phase 5: Machine setup error13Phase 1: Pump fault130Single Rotor Position Sensor error131Repetitive Rotor Position Sensor error132Phase 1-4: Single current trip133Phase 1-4: Repetitive current trip134Phase 4136Motor stall14Phase 1: Pump connection fault144Phase 115Phase 1160Bowl engaged during agitate161Phase 2-5162Phase 3-5: Brake deceleration time-out fault163Phase 4-5164Phase 4-5: Brake function time-out fault17Phase 118Phase 119Phase 1192Phase 4-52Phase 120Phase 1
View all 87 error codes
22Phase 123Phase 125Phase 5 IW: LCD initialisation error28Phase 129Phase 13Motor Controller RAM error during initialisation procedures.30Phase 132Phase 1: Pump circuit error33Phase 1: Water valve fault34Phase 1: Brake resistor fault35Phase 1: MC reset error36Water leak fault37Pump block error38Pressure sensor fault39Tap or pressure sensor tube fault4Phase 140Bowl dis-engaged fault41Temperature sensor fault42Phase 143OOB switch fault44Phase 2-545Phase 5: Display fault46Phase 5 IW: Display EEPROM check47Phase 2-3: Bowl dis-engaged fault48Phase 2-5: Hot and cold valve fault49Phase 2-5: Cold valve fault5Phase 150Phase 2-5: Hot valve fault51Phase 5 ECO: Recirculation fault52Phase 5 ECO53Phase 2-5: Rotor Position Sensor fault54Phase 2-5: Motor / Motor Control step fail55Phase 3-556Phase 4-5: Bowl check fault57Phase 4-5: Motor Controller fault58Phase 4-5: Pressure transducer fault59Phase 4-5: Display Module fault6Phase 160Phase 4-5: Motor Controller fault61Phase 4: Motor Controller fault62Phase 5: Pump fault63Phase 564Phase 565Phase 566Phase 5: Pressure transducer out of range error7Display micro has found a RAM error while testing RAM.8Phase 181Phase 2-382Phase 2-383Phase 2-384Phase 2-385Phase 2-386Phase 2-387Phase 2-388Phase 2-389Phase 2-39Size setting error

Service modes (7)

  • Demonstration Mode1
  • Diagnostic Mode1. Turn power on at the wall power point and off at the console. 2. Press and hold the WASH…
  • Diagnostic Mode (IW)1
  • Option Adjustment Mode1
  • Option Adjustment Mode (IW)1
  • Size Setting Mode (IW)1
  • Size Setting Mode (Phase 4 and 5)1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Fisher & Paykel washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass