mypros+
Error code reference

Samsung Air Conditioner Error Code E270

Suction breakaway error.

Samsung codesSamsung air conditioner codes

Suction breakaway error.

MyPros+ Max

Get the full diagnostic procedure for E270.

  • Step-by-step tests with expected resistance, voltage, and continuity values
  • Wiring diagram references and connector pinouts from the OEM service manual
  • Verified part numbers when replacement is required
Get the full procedure

$29/month · Cancel anytime · Or $9.95 3-day pass

What E270 means on a Samsung air conditioner

The E270 error code on a Samsung air conditioner indicates a suction breakaway error, which refers to a fault condition detected in the refrigerant suction line circuit or the suction pressure sensing system. In a typical split or multi-split system, the suction side of the refrigerant loop carries low-pressure refrigerant vapor from the indoor evaporator coil back to the compressor. When this error triggers, the system has detected an abnormal condition on the suction side, such as a sudden loss of pressure signal, an unexpected pressure drop, or a sensor reading that falls outside acceptable operating parameters.

The most common sources of this fault include a failed or disconnected suction pressure sensor, a refrigerant leak causing abnormally low suction pressure, or a blockage in the suction line that starves the compressor of refrigerant vapor. In some cases, a faulty expansion valve that is stuck open or closed can also produce suction pressure behavior that triggers this error. Electrical issues such as wiring harness damage, corroded connector pins, or a shorted pressure sensor can send erroneous signals to the control board and produce the same fault.

Because this error directly involves the refrigerant circuit and compressor protection systems, continued operation with an active E270 code can cause compressor damage if the root cause is an actual refrigerant or pressure issue. Technicians should check suction line pressure with gauges, inspect the suction pressure sensor and its wiring, and verify refrigerant charge before attempting to reset or restart the unit.

Source: manufacturer service documentation.

Common causes of E270

  1. 01

    Failed or disconnected suction pressure sensor

    Part replacement

    The suction pressure sensor may have failed electrically or come loose from its connector, sending an invalid signal to the control board. Check the sensor's wiring harness and connector for damage, corrosion, or loose pins.

  2. 02

    Low refrigerant charge or refrigerant leak

    Part replacement

    A refrigerant leak can cause suction pressure to drop below acceptable limits, triggering the breakaway fault. Connect manifold gauges to confirm suction pressure and inspect the system for signs of leakage such as oil residue around fittings and coils.

  3. 03

    Blocked or restricted suction line

    Wiring / connection

    A restriction in the suction line, such as a kinked line set or a clogged filter drier, can starve the compressor and cause abnormal suction pressure readings. Inspect the suction line for physical damage and check system pressures to identify a restriction.

  4. 04

    Faulty expansion valve

    Part replacement

    An expansion valve that is stuck in the closed or open position can disrupt refrigerant flow and cause the suction pressure to behave erratically, triggering this error. This typically requires pressure testing under operating conditions to confirm.

  5. 05

    Wiring or control board fault

    Part replacement

    Damaged wiring between the suction pressure sensor and the main control board, or a defective control board input circuit, can produce false readings that trigger E270. Inspect the full wiring harness for chafing, burns, or moisture intrusion.

See the test procedure for each cause

Frequently asked questions about E270

What does E270 mean on a Samsung air conditioner?
E270 is a suction breakaway error, meaning the system has detected an abnormal condition on the suction side of the refrigerant circuit. This could involve a failed pressure sensor, a refrigerant leak, or a restriction in the suction line. The unit shuts down to protect the compressor from operating under unsafe conditions. A technician should diagnose the root cause before the system is restarted.
Can I fix the E270 error on my Samsung air conditioner myself?
Some causes, such as a loose sensor connector or a kinked suction line, can be identified by a knowledgeable DIYer. However, diagnosing and repairing refrigerant leaks or replacing pressure sensors typically requires specialized tools such as manifold gauges and EPA-certified refrigerant handling equipment. It is recommended to have a licensed HVAC technician handle any work involving the refrigerant circuit.
Is it safe to keep running my air conditioner with an E270 error?
No, you should not continue operating the unit with an active E270 error. If the underlying cause is a refrigerant issue or actual suction pressure loss, running the compressor in that state can cause serious and costly internal compressor damage. The system is designed to shut down when this fault is detected specifically to prevent further harm.
How much does it cost to repair a Samsung air conditioner E270 error?
Repair costs depend on the root cause. Replacing a suction pressure sensor typically runs in the range of $100 to $250 including labor. If the issue involves a refrigerant leak, costs can range from $200 to $600 or more depending on the severity and the amount of refrigerant needed. A faulty expansion valve replacement can range from $300 to $700 including parts and labor.
Will resetting my Samsung air conditioner clear the E270 error?
A reset may temporarily clear the error code from the display, but the fault will return if the underlying cause has not been repaired. Resetting the unit without addressing the actual problem risks compressor damage if the suction pressure issue persists. Always identify and correct the root cause before relying on a reset to restore normal operation.

Related Samsung air conditioner codes

All Samsung air conditioner codes
View all 572 Samsung air conditioner codes

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass